Pre-built Ridge Wallet Apple AirTag Module User Guide

This guide is made specifically for this product.

I. Inserting the Battery

  1. Use the pointy end of the included tool to pry up under the crescent-shaped insert with an "UP" label, and remove it from the battery cavity.
  2. Insert one of the included CR2025 batteries under the "wings" of the battery compartment.
  3. Use the curved end of the tool to push it almost all the way to the end, leaving 1 mm or 1/25" between the battery and the end of the battery compartment.
  4. Secure the battery in place by placing the crescent-shaped insert back into position. You should hear a "click".
  5. Your AirTag is now powered on and ready to pair.

II. Pairing with iPhone

  1. Bring iPhone close to AirTag and unlock it. If you get an AirTag pop-up, simply go through the setup process, if not, continue to step 2.
  2. Download and open the FindMy app.
  3. Tap the blue "+" icon on the right hand side of the screen.
  4. Select "Add AirTag".
  5. Your iPhone should start scanning for the AirTag.
  6. If your iPhone is not detecting the AirTag, make sure the battery is properly inserted as per section I, and try hovering the AirTag towards the back of your iPhone.
  7. Once the AirTag pops up on your screen, simply go through the setup process.

III. Installing onto Ridge or Ridge-style Wallet

  1. Locate the correct side of the wallet to replace. This should be the side on top when holding the wallet with the notch on the top left-hand side (i.e. the side without the cash clip).
  2. Unscrew the 7 screws securing the decorative plate.
  3. Slide the existing aluminum side panel from under the rubber band.
  4. Place the AirTag module in its place, making sure the rubber band sits correctly in its channels.
  5. Screw the decorative plate back on, making sure to gradually tighten the screws in a star pattern.

IV. Removing or Replacing Battery

  1. Use the pointy end of the included tool to pry up under the crescent-shaped insert with an "UP" label, and remove it from the battery cavity.
  2. Wedge the pointy end of the tool in the small gap between the battery and the battery compartment, and push the battery parallel to the device.
  3. The battery should now be free.
  4. To replace the battery, please refer to section I.
  5. Use ONLY CR2025 batteries as a replacement, do NOT use CR2032 batteries.

V. Performing a Hard Reset

  1. Remove the battery by following the steps outlined in section IV.
  2. Remove the device from your FindMy app ("Remove Item" button at the bottom of the device page).
  3. Making sure to use a brand new battery, Insert the battery in just enough for you to hear the chime. If your device does not have a speaker, follow the same steps nonetheless.
  4. Once you hear the chime, remove the battery and re-insert it 5 times in succession, or until you hear a different chime (the brand new AirTag pairing chime).
  5. Your AirTag should now be reset. Insert the battery back in as per section I, and pair it as per section II.